Packing

Die Form Rings

Style DF100
BRAIDED
GRAF
GRAF
GRAF
BRAIDED
Braided Top and Bottom with 45° Angle Cut
Style DF200
BRAIDED
GRAF
GRAF
GRAF
BRAIDED
Braided Top and Bottom
Style DF300
BRAIDED
BRAIDED
BRAIDED
BRAIDED
BRAIDED
Braided
Style DF400
GRAF
GRAF
GRAF
GRAF
GRAF
Die Form
Style DF500
GRAF
GRAF
GRAF
GRAF
GRAF
Die Form with 45° Angle Cut

Mechanical Packing

  • Aramid Packings
  • PTFE Packings
  • Carbon and Graphite Hi-Temp Packings
  • Synthetic Packings
  • Flexible Graphite Ribbon Tape
  • PTFE Joint Sealant
  • Injectable Pump and Valve Sealant
  • Flange Protectors
    • Plastic
    • Hardboard
    • Plywood
    • Pins and Washers
  • Machied PTFE, view details >

All technical advise and recommendation are rendered by Seller free of charge. While based on data believed to be reliable, seller assumes no responsibility.

PTFE Stack Heights
Cross SectionMale AdapterVee Ring Max-MinFemale Stack Height
Plus .000” Minus .005”Max-min Stack HeightMax-min Stack HeightPlus or Minus .005”
0.125.050/.063.100/.0830.125
0.156.062/.063.125/.0830.156
0.187.075/.063.150/.0830.187
0.218.087/.063.174/.0830.218
0.250.100/.063.200/.0830.250
0.281.112/.063.225/.0830.281
0.312.125/.063.250/.1400.312
Plus .000” Minus .010”Max-Min Stack HeightMax-Min Stack HeightPlus or Minus .010”
0.343.137/.063.274/.1400.343
0.375.150/.063.300/.1560.375
0.406.162/.063.325/.1560.406
Plus .000” Minus .010”Max-Min Stack HeightMax-Min Stack HeightPlus or Minus .010”
0.437.175/.063.350/.1970.437
0.468.187/.063.374/.1970.468
0.500.200/.063.400/.1970.500
0.531.212/.063.425/.1970.531
0.562.225/.063.450/.1970.562
0.593.237/.063.474/.1970.593
0.625.250/.063.500/.2500.625
0.656.262/.063.525/.2500.656
0.687.275/.063.550/.2500.687
0.718.287/.063.574/.2970.718
0.750.300/.063.600/.2970.750
PTFE Female Adapter
PTFE Vee Ring
PTFE Male Adapter
Rec. number of V rings per set
PSINo. of V rings
0-4003
400-18005
1800-45006
4500 and up7

Cup & Cone Sets

Cup and Cone packing of PTFE (Polytetrafluorothylene) seal with less pressures than similar “slug” packings.

The cup seals on the packing gland I.D., while the cone seals on the shaft O.D. The combination of the packing acts as a bearing when side thrusts are encountered.

Packing rings should not be cut or slit when installed. These cuts can form a leak and the packing will not seal. To properly install the cup and cone packing, it must be slipped over the end of the shaft.

When ordering cup and cone packing, the following dimensions are necessary:

  • The shaft or rod O.D.
  • The packing gland I.D.
  • The effective stack height